Cloud-electronics CDR-1B Instrukcja Użytkownika Pobierz pdf (Strona 14)

CDR‑1 & CDR‑1F Installation Guide v2.014

3. Check that jumper J1 is in the OFF position. J2 should be set according to the

CDR1F’s position in the CAT-5 “chain”. If it is the nal (or only) panel in the chain

(i.e., nothing is plugged into the POWER OUT connector), set J2 to END; in all

other cases set it to MID. Carefully use tweezers or a pair of ne-nosed pliers for

this operation.

MIDENDOFF

J1 Settings

End of chain Middle of chain

4. With back box: carefully position the rear metal screening box of the CDR-1F

into the back box, taking care that the CAT-5 cable(s) and PSU wiring (if used) are

not under any strain. Insert the two M3.5 raised-head screws supplied through

the xing holes in the front plate and engage them in the threaded inserts or lugs

of the back box. Tighten until the panel is neatly ush against the wall – do NOT

over-tighten.

Without back box: carefully position the rear of the unit in the hole, and x the

front panel with screws of a type and length appropriate to the wall construction.

No. 6 woodscrews are satisfactory provided that timber battens are available

either side of the hole.

CDR-1F Dimensions

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Cloud-electronics CDR-1B Instrukcja Użytkownika Strona 14